Recent content by Lex-Us

Sorry, it's been sold. Was just the front

In my experience, you'd be better off not trying to install any kind of tune. I've deal with tuning for years on diesel trucks. My truck was a little over 1000hp. It's a very fine line to get it perfect. Most of the time, there's a problem. It takes a lot of logging to get it right. Not...

at least you get something for the mark ups. Ceramic coating, interior protection were a couple things I had to pay extra for. I paid it reluctantly as it was a little more than aftermarket might have been but, I drove away within 2 weeks, not 2 to 6 months

sorry to see the issue you've had. Don't have a lot of sympathy though. You said you're an engineer. You of all people should know then, the millions of dollars these car companies put into the R&D. Cold air intakes and map tweakers are mostly hype. Maps are generic and mostly add fuel and...

It wasn't too expensive so, I got it. Just decided I didn't need it. I'm very rural and don't have the need some city folk might. I don't mind taking the loss to sell it.

don't believe this guy works on the "E"KDSS but, if anyone knows their way around the system I'd say he does. In case someone was interested...... Dr KDSS - KDSS to the next level

depends on the setting you have it on. Depends on the setting you have it on. Eco, Sport, Sport+ will lock them in place. Normal & comfort the computer controls them. It's really not meant for cruising. It's more for when offroading

I decided not to install this cam. Everything is BNIB as I received it. It priced to move and not sit around my house anymore. $125 shipped in the CONUS

I'd be livid. As you said, those areas will rust as soon as water gets on them. Looks pretty thin as well. I got the same thing from CBI. I ordered their ditch light brackets. They didn't come with any rubber grommets as they should have. A couple days after emailing them, the response...

I stuck with the oem rate. Just added a little height. I don't have that kind of weight back there so, there was no need to increase the load rate. If I were you though, with what you have... I'd do it. Springs are cheap and easy to install so, if you don't like it, it's not a big deal to...

no problem. It's a 30min job ( on a lift ) to replace them if you decide to do it.

My set up might be a little different than others. I have a bumper/winch on the front. The ride was good with the out of the box Kings and oem springs but, it needed a little something. I felt the rear was a bit spongy. I added preload to the Kings and because of that, Dobinsons with an...

You basically have a pile a junk. All mine went to the dump except for the crash bar. I'll be getting $.25 a pound for that :ROFLMAO: